Acrylic Cutting tips Laser Cut Acrylic much cleaner FREE FILE

As shown in the video these really help to keep the acrylic cuts much cleaner quick and easy improvement

[grahamwhitehead]

great video thanks, I use Neodymium magnets to hold the material above the honeycombe and larger ones to keep some material from bending or hold down slightly bent material

[smileinanenvelope]

Thank you. It's super helpful. Cuts so clean and love it.

[RobertLugg]

A more pointy tip might make them easier to get on and off. Great idea.

[grahamwhitehead]

i know its been a while, but where do you get your acrylic from, i understand that cast is best

[anthonymyers-]

Fantastic video! Thank you for sharing

[danekline]

Awesome video, I can’t wait to try this. I just started engraving acrylic on my CO2 and having issues with flash back and build up on my lens. Any recommendations to prevent the build up? I have my lens 3mm away from my material and turn off assist.

[RastaOnABike]

I wish i could cut acrylic like that. I am only at diode budget at the moment. Co2 dreams

[jeffstewart]

HI FROM CALIFORNIA. GETTING A FOG BAKED INTO THE ACRLIC SURFACE THIS WINTER. DO YOU KNOW IF ITS TEMP OR HUMIDITY CAUSING THIS?

[phototec]

Thanks for the video. I did not understand why you said to paint them RED?

BTW: The audio volume is much better now.

[syedmohammedali]

What is the set point for acrylic cutting in lightburn? Kindly someone tell me

[reytrinidad]

thanks so much, your video helped me a lot.

[primate]

Can clear acrylic be cut like this using a diode laser?

[TheScaleBuilder]

are you using a compressor for the air?

[BlackOx]

Once upon a time, my wife had burned my laser machine. Just because of using acrylic distances.... Do NOT make distances from materials, that can burn. Ever. Especially acrylic.

[dogodogo]

i want to make something like sawtooth measured by TPI(teeth per inch) so basically mm for each tooth, it possible to captured small detail on acrylic until 24 TPI(1 mm/teeth)?