Jennair down draft oven front panel replacement

W10314417 Jenn-air front panel replacement tricks. Also note a screw on each side of oven must be removed to get panel off. Limited input on control panel and some error codes on boot up. Can test try bootup w/o control panel cable attached should be no error code. Oven cost about 2600 and panel cost 210 its worth a shot worked for me.

[guycote]

We had a handful of buttons not working. Replaced the panel and door seal, very straightforward. Everything works like new again! Thank you.

[samhoskins]

I just replaced my panel and door seal. Easy Peasey, thanks to you! BTW - if your control panel goes out, you probably should also replace the oven door seal. A heat leak can lead to overheating the control panel. Thanks!

[BeerkegGarage]

That was helpful. Im replacing me gasket also, I think that will help reduce the amount of heat leaving the top of the oven

[markhancock]

You dont by change have video of the removal and replacement, do you??

[underourrock]

Would a bad control panel cause the oven to stop heating? Maybe the cancel button is triggering? (I don't get a beep when it just stops / oven turns itself off.)

The time display stays on, so my first thought is something is wrong with the control board.

Edit: hindsight - the seal on the door wore out, let heat escape which then damaged the control panel over time. A new door seal and eventually a new control panel for $300+ finally fixed it. Cheaper than a new oven though.

[ruthmurcia]

This video is so helpful! where can I get the touch pad by itself this days?

[cmumjeo]

What is the model number of this stove?

[yamspaine]

thanks, any chance it was the ribbon and is repairable?

[jeffreykilpatrick]

How did you get the front panel off ????

[Slay]

Our down draft oven is getting up to 600 when its set to200, can that be fixed ?

[htoddsnyder]

Thanks for the video - I'm looking for that exact control panel & having difficulty finding it! Do you have the part number and/or the site where you bought it? Thanks so much!

[underourrock]

I would have really liked to see how you removed the control panel. I have that exact one, I think, and I've removed all the screws I can but it doesn't want to lift off or twist upward and off.

My range top is siliconed down to the counter top, so if the top is supposed to lift up, I'll need to remove the Silicone.

Any advice before I get too far along and break something would be very much appreciated.

Edit: I found your other video. Thank you very much! I did have to remove all the silicone to get at the side screws I couldn't see.

[howardtoob]

I'm about to replace mine. Same unit. These ranges are complete garbage.

[mrflorida]

Go part at Sears direct there is a black one and stainless too either work