replace inducer motor ( trane xr 90 furnace)

remove and replace an inducer motor on a Trane XR90 furnace...parts/material links below
Don't forget to 👍and SUSCRIBE, thnx !

[mattrick]

Service tech wanted to charge me an absurd amount of money to do this. After finding this video I realized I could do it myself and saved a ton. Thank you!

[rickgripman]

Great video, didn't realize there was a gasket for the back side! Thanks for the heads up.

[TruckThisGarage]

I’m assuming my bearings are going bad. Louder than usual. Like higher pitch winding noise? Think I’ll try replacing this. Don’t want it to seize up during a cold snap this winter. I also had the drain freeze up last year and it got water in it causing a gargling sound.

[jaiceylo]

Thanks so much for this video!This is exactly what I need and I follow your instructions and fix my furnace successfully. 😊

[Ian-yuhx]

Thank you for taking the time to record this video. I just ordered the parts and will be tackling this project soon. Thanks again

[marks]

hey cool vid. I have the same issue with an XL90 super efficiency. The inducer motor sounds fine but the fan inside the housing is making the noise. The design is different for sure. It's a Trane BLU040K930B4 Furnace..

You're the closest repair vid i have seen. I'll keep lookin around for assistance. Nice work.

[Jeff-rkhq]

I really like your style and genuinely appreciate your vid

[modquad]

I have an XE90 that’s leaking water onto the sheet metal right below the inducer, but it’s not coming from the inducer as all drain lines are clean. I’m assuming there must be a tray or something on the burner side that’s leaking as there’s a hose opposite the inducer that’s clean, but no water draining through it. Looks like there’s a removable panel behind the inducer, so I plan to pull the inducer and that panel to get access.

[illegalSAUCE]

Thanks for suggesting the Permatex Red RTV silicone high temp gasket maker! The gasket for the my new motor is backordered until the end of January and this saved me a ton of time and money! Would you recommend taking out the motor and putting in the gasket once it comes back in stock or is it fine to leave the motor in with the silicone? Thanks!

[BrooklynBurg]

Aside from the electricity, do you turn gas off as well?

[Phunco]

Thanks for the helpful video. My motor was screaming like a banshee! Well it got louder this week, so I looked the part up myself and located it online. After watching this it took me about 15 min to replace. Most of that time was fussing with the weird little plastic clamps they used on the drip line. Not easy to remove like the old metal ones. You drink domestic or import beer?

[ozarkdaredevils]

Will this fit a Trane XB furnace ? it looks the same ? Thank you

[marcustaylor]

The hole that you show at 2:53, basically where the exhaust comes out through the inducer fan. Is it normal to have wetness in there or is that a bad sign?

[partshnc]

The impressive video quality combined with your top-notch repair skills makes this video a valuable resource for anyone looking to replace their furnace’s inducer motor. In case any of the viewers are looking for Trane inducer motor and other Trane furnace spare parts, check out our site.

[rhymereason]

If you haven't done so already, you should get that dark spot on your left hand checked out - looks a lot like possible melanoma...