How to Replace an Axle on VW/Audi Models

Today we show you how to replace an Axle on a B7 Audi a4. This video can be used on any VW and Audi, but make sure you always find the torque spec for your specific application.

Links Talked about in this video

Driveshaft for B6 and B7 Audi A4 (Automatic)

Control Arm Bolt

Control Arm Front Pinch Bolt Nut (12 x 1.5)
---------------------------------------------------
This Video was shot at our VW and Audi Specialty Shop
DAP Repair
10308 Bailey Rd
Suite 408
Cornelius NC 28031
----------------------------------------------------
Shop for VW and Audi Parts Here

Check out our VW/Audi Shop located in Cornelius NC

More info on DAP Reward Credit

[richardredfern]

You can get them both out without removing anything else by lifting up the control arm with an additional jack to the regular driving height. That way you have enough space (at full left/right turn - take out key for steering lock) to get the axel out. Try various positions and angels of the axle but it is definitly doable, even with the S-Line suspension. Just finished this job yesterday.

[demelitia]

Turning the steering wheel to full lock, taking the keys out of the ignition so the steering lock engages and then jacking the upright/knuckle up to take the sag out of it often allows you enough room to remove the axle without taking any arms off.
Definitely works on b5.5 Passat’s and probably related models.

[robinupham]

As always, best Audi repair videos I've ever seen.

[TheFlyingPLiner]

If you are doing this on a car you actually care about and plan to keep long term I strongly suggest getting upgraded axles from Raxles. Little expensive but they make great products for VW Audi.

[joelopes]

You couldn't have posted this at a better time. Did the front axle on my B8 S4 this morning and this was super helpful!

[Strange_Brew]

I bought the aftermarket axel passenger side and I removed the cheap grease and repacked it with Mobil 1 grease. Makes a big difference.

[TheWinterfan]

For anyone doing a B8.5, I was able to do the pass side without undoing any control arms or jacking up the suspension. Turn the steering wheel fully left, then angle the outter joint as much as much as possible to where the axle forms a check mark or V where the point aims towards the rear.

[saladfork_]

Great video! Really wish I had a lift and air power too, haha. I just did this on my B6A4 Avant. For the passenger side, I had to turn the wheel full lock to the left and then I opted to remove the plate/shield part just above the axle that is largely what causes there to not be enough play to remove it as easy as the driver's side. It's held on by three 6mm bolts. I removed the two on the side and left the middle one loose so it could move freely but stay connected.

[schulenbergpatrick]

I love your B7 videos, I don’t have a B7, I just really like your attitude in these vids. Keep it up 👍

[jsnichols]

I just had to remove the axle from the hub on my '13 Jetta SE 2.5 in order to facilitate a strut change. I worked for 30 or 40 minutes to free the axle bolt (I actually expected longer), but to my delight the axle slid right out like butter. The inside cavity was immaculate, no signs of wear or rust - and I'm in Ohio!

[dubbified]

Nice vid! I'm replacing some axles due to grease loss, covered under warranty.. DONT GO CHEAP ON YOUR AXLES! doing it 11 mos later SUX.

My suggestion is to expand on what you do to build your business when you are doing this project. There are always things to do "while in there" surely worthy mention!

[Chrissurf]

The 08 A3 wagon is 12 point 15/16".it had 80 lbs on it .drop your other wheel to ground .real world floor jack style.take your pipe from the floor jack put it on your breaker bar....get a 14 -16 m triple square to loosen lower strut mount bolt. That's how mine is set up up

[Nefariousrouge]

That screwdriver in the rotor trick… how did I never figure that out!

[MSoloWacck]

Uploaded 32 Seconds ago👍🙃 thanks for the very very informative videos and the entertainment 😂

[doca]

Good video.
Helps when you have a lowered C5 RS6 that’s tearing boots twice a year.

[jeremyhicokraddad_mtb]

Thank you soooo much for this video!! Did them at the same time as coilovers. Super easy removal if you break them loose, take the stock suspension out, put new axle into place, and torque axle down after the new suspension is in

[sebol]

Man you are the best. I did my front axle replacement on a4 b9 ani it is so simple with your tip how to remove axle only by moving steering wheel. Respect bro 😁

[michellewoodruff]

Thank you for a great video. Also the comments helped a lot. This is not a easy job and I think my brother is ready to blow this audi into flames. Love my Audi but man what a pain to fix

[luismarty]

Thank you. What is the front axle bolt torque specs on a 2018 passat with a 2.0l ?

[luismarty]

Also, are the ribbed and non ribbed bolt interchangeable.