Adjust your motorcycle chain in less than 30 seconds

[powwow]

You just used a torque wrench to loosen a fastener.

That's rule number 1 with torque wrenches.

[skylerrash]

Remember to spend 3 months finding a motorcycle stand that actually works for your bike

[photou-motou]

Using center stand to adjust chain slack is not advised, since chain is not loaded as it would be if you'd use a rear stand.

[DA-pbyl]

So much wrong in this video. Don’t use a torque wrench to loosen anything very tight, also don’t check/adjust the chain on a center stand, it unloads the suspension, the chain needs to be checked on the bikes own weight. Just read your manual.

[troyholland]

Personally I’d want my chain a bit tighter then that especially on a sports bike a dirt bike I usually like to have close to 2 inches of slack but a motorcycle only like to have maybe a little more then a inch

[gixxusmetalman]

How do you stop chain going tight when tightening wheel nut?

[sonnyday]

so you do not need to tighten the adjusting nuts after the axel nuts have been tightened?

[SeePatPlay]

Ah the adjuster.. didn’t think of that!

[Riko_]

Can you make a video on how to do it on the benelli bn 125? I have the same bike

[HOPPOVERSION]

very informative my brother, is that a DID CHAIN?

[pookiewookie]

The slack before and after seems to be about the same no?

[Keldren.]

But how do i keep it from loosening back up in 30 seconds too..

[yamahasuperbike]

That chain didnt need adjustment. As soon as the bike came off the center stand, the slack tightened up.

[itsnedram]

You actually measured your slack with the bike on its stand? :/

[robbcraig]

Irresponsible video. Learn nothing from this folks!

[TheQuanzy]

'How to adjust your chain in 2 minutes' without giving any relevant information and using the wrong tools. Big fail!