Flashlight hack | How to increase flashlight brightness

Guide how to modify flashlight tail cap spring bypass to increase brightness. Enjoy this video

Please subscribe my channel Lesley TV and share my video

[RC_Trailblazers]

You can achieve the same thing by using aluminum foil and no solder. You're basically just increasing the contact patch instead of running through the coil of thr spring you're allowing more current to pass through allowing a brighter light. Also shortens your LED life span.

[hulkgqnissanpatrol]

How to overheat and push solder under a PCB 101

[sandmanbub]

Much easier to solder and a much better bond if you heat the spring and wire and let them melt the solder. If you only heat and melt the solder, it will not adhere as well and it will be hard to get it to stick at all until the hot solder heats the wire/spring enough. That's why the first attempt caused the solder to fall from the intended connection point. "Tinning" the soldering iron helps transfer heat to the place that you want the solder to melt and stay put.

[edmondaaed]

mantap bro.. x copyrights kh sound track?

How many percent can you increase the lumen by this?

[miller]

semoga dibaca, bang, spring di drivernya perlu dibypass juga gak? kalo kata master2 di grup fb perlu juga bang, gimana pendapat abg?

kalo dibalas, nanti aku subscribe, makasih

[tortugasgadgets]

Guna bateri murah ok tak untuk max lumen?

[lakasund]

Hello. Good video. must i spring bypass the driver too? too get 5-10 % more power.