how to make high torque servo motor .

preview_player
Показать описание
makeing high torque servo motor using 9g servo motor
Рекомендации по теме
Комментарии
Автор

If i replace receiver with servo checker, still it works?

radyanradiantradiance
Автор

Hi, i have a similar design, but it doesn't go to exact center after left or right when i release the stick. Right and left have their different home position, do you know why would it be? There is no mechanical backlash.

automacnc
Автор

Hi, congratulations for your project, it's very cool & simple. This is exactly what I what search. But if I don't find this piece (IBT-2), what another parts can I use it?. Please, I'm from Haiti; it's not easy to find & buy it.

DocBen
Автор

I have 24v 160kg broken servo moter. Can i give servo moter signal ( 24v ), directly to this pwm pin.

electricalroom
Автор

Where did u get the IVT2 Circuit board? EBay or specialist shop?

seonblackman
Автор

boa noite amigo sou do Brasil vi o seu video e gostaria de saber se tem como faser a mesma coisa com o drive L298N ligando direto no recepitor sem precisar de arduino seria pra controlar a direçao de um carrinho de controle remoto.

arthurpingo
Автор

Can I use a potentiometer with the ibt-2 board instead of the receiver with the remote control?
Thanks

LeandroJSilva-fjfv
Автор

Hey dude. I’ve connected my IBT2 motor controller like you have in your video and can only get it to work one way. Do you have any suggesting that I may have done wrong ?

kevinknowlton
Автор

How efficient is the driver ? What the voltage drop across it ?

angelleal
Автор

It works only in one way motor direction, any suggestion?

mohamadbakri
Автор

Need similar but want use 3 position switch from car lights leveling.... I use this for motorcycle rear suspension preloading... Soft middle and hard.... Have motor actuator integrated resistor to control piston position 5ohm...motor have 3 Amp on power load probably max 10 Amp

mcg
Автор

Hi sir, When you connect regulator, did you connect the output with output of board

nguyenduckhanh
Автор

Hi, i wanna ask, how do you make the 5v regulator?

MNHBK
Автор

How do you connect with a circuit board input

nguyenduckhanh
Автор

hi, i'm from Brazil, your project is very good, but i have a doubt at minute 1.30 what piece is this? which name of this piece? thanks.

Kombochilandoporai
Автор

can it be done without remote control
to be controlled only by arduino in degrees
as a simple servo motor is controlled

keca
Автор

how do you make 5V regulator
Can you help us more specifically

nguyenduckhanh
Автор

Hi do you have schematic diagram and parts?I don’t understand the connection fron servo connection going to receiver.thanks

SilverVioly
Автор

Hi modal. As.
💗 Nice. Mama. 😍

NizamUddin-tocj
Автор

Hi sir I want to make it turn automatically with adruino. What should I do. Thank you sir

nguyenduckhanh