IllumiAquashield - Samsung Galaxy S10 Screen Protector Installation Video

"IllumiAquashield Screen Protector Installation Video.

*Written Instructions Below*

Case Friendly:

Maximum Coverage:

INSTALLATION INSTRUCTIONS
• Prepare a clean & dust-free workspace to perform the installation.
• Wash your hands to remove dirt and oils.
• Turn off your device and remove the battery only if possible.
• Spray some installation solution on your microfiber cloth and clean the surface of the device.
• Visually inspect the protector and match cutouts to where they’ll line up on your device.
• Spray your fingertips with the non-toxic installation solution.
• Spray some solution on the top side of the protector.
• Gently peel the protector away from the backing while minimizing contact with the adhesive side.
• Spray a moderate, even coating of solution onto the adhesive side that covers all areas.
• Gently lay the protector adhesive-side down onto your device. Center and align the protector to match your device’s cutouts and edges.
• With one hand, hold the protector in place. With your other hand, use the squeegee to push out excess solution and air bubbles. Do not use excessive force as doing so may stretch the film.
• The protector may move during the squeegee process. Constantly stop and readjust the alignment of the protector before continuing to squeegee the solution out.
• For devices with curved edges, allow the protector to dry for a few minutes before gently pressing the area down with your finger. If it does not stick, wait a few more minutes and try again.
• Once the installation is complete, we recommend allowing the protector to dry and cure for a period of 12-24 hours before turning it on and using it. Micro-bubbles, streaks, or cloudiness may remain immediately after the installation, but these will disappear in a day or two."