Geberit Type 240 Flushing Valve - Installation

Показать описание

Installation film demonstrates the fast and easy installation of the Type 240 (2018) flushing valve into a exposed cistern. Also shown is the installation of the Type 333 filling valve.

Die Montagefilm demonstriert den schnellen und einfachen Einbau des Spülventils Typ 240 in einen offenen Spülkasten. Ebenfalls dargestellt ist der Einbau des Füllventils Typ 333.

ID: 2205741

If you need technical support, please contact the local technical support team.

Please note: Videos do not replace installation manuals. For installation purposes, please use the respective Geberit installation manuals.

Рекомендации по теме

Комментарии

Świetny instruktarz, nawet osoba z dwoma lewymi rękoma da sobie radę

fotomantrojmiasto

Merci pour cette vidéo cela m'a permis de démonter le mécanisme et de le nettoyer à fond

allvan

Multumiri din Romania 🇷🇴🇷🇴🇷🇴 Nu m-as fi descurcat fara acest video ‼️🇷🇴🇷🇴🇷🇴

TabarceaTD

Наложил огромную кучу - все смыло! Спасибо!

playtoday

Installed right now. Toilet again working like new :)

bojer

Very nice and very useful videomanual. But even though I had difficulties to set the amount of flushed water. I couldn't flush more than 5 liters (no matter how I set the blue thing). It took me quite long time to find out why. The manual says to cut the white tube according the table. According the water level + distance ≥20mm. The sign "≥" means "greater than or equal". So I cut 35mm which is ok according the sign. And that was a mistake. You have to cut precisely 20mm, not more than 25mm above water level !!! Afer doing that, everything was ok. And one more thing: No manual describes where to put back the blue rod which you've disconnected at the beginning. It's not obvious for everyone that you have to put it in the same hole number as the number which you set the black sliding top.

Andrej

It would be good if the installation manual shown in the video instructions was available. Searched for it everywhere on line with no success.

brianwithers

Bardzo fajny i pomocny filmik. Jedyne do czego mógłbym się przyczepić na filmiku jest pokazane ze podczas napełniania zbiornika woda wypełnia rurę przelewową a nie powinno jej tam być. Zabrakło mi również instrukcji regulacji małego spłukiwania, aby ustawić 3l chyba że to idzie z automatu skoro duże spłukiwanie ma 6l.

tomaszwilk

i have instaled the flush valve but it not works properly. the problem is- when i flush water i have to press the button all the time because when i release the button water stops flushing. why? what to do to fix it?

gitfunfel

Is it necessary to cut/saw the top off (after measuring)? What happens when I don't do this? I haven't done it now, and it seems to be working. (The top is 2 cm above water lever.) Thank you.

tvermeer