🛠 Connecting Your Dash in NSP | TECHNICALLY SPEAKING

In this software walkthrough, we take a look at connecting and sending data to your Haltech uC-10 or iC-7 dash.

The Haltech digital dashes are compatible with Haltech CAN, OBDii, third party CAN, direct inputs or a combination.

Grab your laptop, and learn how to make the most of your new dash!

Got a topic you'd like us to cover? Leave it in the comments section!
-----------------------------------------------------------
Liked this video? Here are more like it:
----------------------------------------­----------------
Don't miss out on our next video - subscribe to our channel.
----------------------------------------­----------------
For more Haltech goodness check out our:

00:00 Introduction
00:18 Is your dash compatible?
00:49 Setting up Haltech CAN
03:07 Setting up OBDII
04:33 Setting up third party CAN
06:06 Setting up direct inputs/stand alone

[MicrowaveNut]

Any plans to have more custom looking dash gauges? I just purchase this for my Supra build and wouldnt mind being able to go for a more retro gauge look ❤

[govbentley]

I got a set of New Vintage USA gauges for christmas and I have discovered your Haltech ECU product just recently and from just seeing the videos I must say I am impressed to the point that Haltech will be used on my 75 Vega swapped with a 2007 LS2 Corvette stock engine and a 2008 4L65e trans . My concerns are my gauges, oil, temp, volts, fuel, speedo and tach . How will your Haltech system connect to my NVU gauge set up ? The instrument cluster area is tiny in my Vega and the set up I want to use is the perfect size for it . I hope this is simple . Can you help ? Thanks and God bless .

[denisbassom]

Good tutorial but still awaiting confirmation on WHICH channels you receive from Motec...it doesn't seem obvious from NSP, or I am being thick.

[nomansland]

Are you able to stream generic sensors configured in the ecu and see them on the dash? This was previously possible but doesn’t seam to be anymore?

[stephenb]

Can you add PD 16 output data display on nsp ic7 like you had on icc software.

[rchingy]

When can we expect to be able to change our logos again? :)

[regularguy]

is there a way to put a start up delay on tyre alarms so that they all dont come up on the ic7 screen at start up?

[MrQuartermilerun]

Is there anyway to daisy chain a third party ecu through a wb1 and have them both work?