How to Replace Mas Air Flow Sensor 2007-2013 Chevy Silverado

Buy Now!

This video shows you how to install a new TRQ MAF sensor in your 2007-2013 Chevy Silverado. The Mass Air Flow (MAF) sensor determines the mass flow rate of air entering your vehicle. A trouble code indicating the sensor is not working properly could be because it is dirty, malfunctioning, or damaged, in which case your vehicle may run poorly or enter limp mode. Fortunately, sensors are typically easy to replace.

This repair was done on a 2009 Chevrolet Silverado 1500 LTZ 5.3L Extended Cab Pickup 4-Door 4WD Automatic and the process should be similar on the following vehicles:
2007 Chevrolet Silverado 1500
2008 Chevrolet Silverado 1500
2009 Chevrolet Silverado 1500
2010 Chevrolet Silverado 1500
2011 Chevrolet Silverado 1500
2012 Chevrolet Silverado 1500
2013 Chevrolet Silverado 1500

Tools you will need:
• T15 Torx Driver

Check out our playlist:

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[TRQ]

√ Watch the Video
√ Do it Yourself
√ Save Money

[PureNationalism]

I love how your harness always just pop right out. Almost like you have someone labor on it and then you just come in a pop it off no problem

[bobloblaw]

This video is on the part for a 2004 Chevy Malibu 3.5 V6 engine. is this the same procedure is shown here for the Silverado?

[camerongeddings]

Do you replace this if you have a Po113 code?

[perezi]

This is for the 09 and up correct? The 07-08 are different?

[foshiix]

if i swapped a 6.0L from a 5.3 but still using the 5.3 intake and MAF will that cause it to misfire or run poorly?

[mannyhernandez]

Should disconnect the negative from the battery first?

[pablomacias]

Is it better to disconnect battery before disconnectting?

[honeyiroam]

Thank you so much! Super Duper helpful and going to do it right now!

[masterjhon]

I replaced my mass airflow and the fuel range is going down pretty quick. Do you know what cause?