Mitutoyo CMM - Dedicated vs Non-Dedicated Alignments

Should I use a dedicated place on the table to check my part?

[NateFreelRacing]

For the manual alignment will the cmm compensate for height changes based off of fixturing? Say I com back to a set of parts after 6 months and I do not use the exact stanchions that had been previously used. Thank you this has been a great video series you have produced.

[AmanSharma-zpze]

Part alignment process for making a program to measure different parameters

[bobbauvian]

this great thank you very much. do you have a video showing how to write an alignment program on a manual machine.

[edgardelgadorivera]

Can you show how you did in the screen software?

[joecarosiello]

Is there a way to rotate the probe with the joystick? Moving it 90 degree angles etc?

[RAHULDAS-crfl]

Sir how to measure flatness perpendicularty and roundness plz make a video on this topic