Nexus 6 Charging port replacement using Hot Tweezers

⭕ We are an Amtech Flux Distributor. Buy AMTECH NC-559-V2-TF Flux

UNI-T UTi260B thermal Camera

Grinding pen

Low Melt Solder

NorthridgeFix T-shirts

=================================================== If you are local, drop in and say hello
NorthridgeFix
19365 Business Center Drive, Unit 7
Northridge, CA 91324

Phone: [phone]

[VsUK]

I had a go at replacing the micro-usb port on a Amazon fire 7 tablet. It took me 5 hours & a lot of retries. But I managed to do it. It looks ugly, but it works. Did it for a friend who didn't have money to buy a new one as a favour. Never done this type of soldering before, or any soldering really. But I'm learning a lot from y our video's, do ty :)

[justinspiredfallout]

Awesome as always. Now I want to buy some hot tweezers. :)

[jeps]

Thank you for teaching how to change charging port. :D

[manojgajjar]

For a child 👍 😀
Gret job, , Thanks sir 💐

[Александр-ялэ]

Hello. Good idea! Take note! What solder and flux do you use? Thank you! Like!

[Swenser]

That's magic. How does the heat transfer to all the port pins when just grabbing the port on each side. I cannot comprehend. Surely you had the hot air on it at same time?

[DLSDKING]

On the back of the board there is a port (a small hole)for another microphone(the mems mic with steel case) which you missed.

[gck]

this part is very challenging. i hate soldering charging port.

[essambakhashwein]

MashaAllah akhi, great videos to learn, i have 8 email addresses and all subscribed to your channel🙏🙏

[donald]

Those hot tweezers really impress me - you do stay busy I see

[zxrjimmy]

Smaller solder tip would have been help, got the jbc nano here a bit back and it's perfect for tight spaces

[petarpocakal]

Hi, where did you buy this box full of usb connectors?

[ravikomar]

Hi... How much you will charge to change micro USB charger port for honor6x phone ? May I know... And please tell how to send phone to change usb port? To yours

[villages]

I think nexus intentionally put the components that close to discourage port replacement

[RioTintoGoAwayFromDrinaRiver]

You are using to much soldering flux (about 5 times more than nesessery). Put desoldering flux on some dentist tool than apply on the pcb. For connectors you should use only hot air (ftom the bottom side) with small ammount of flux.