Headlamp Globe Replacement - Holden Commodore VF - How To DIY

In this video I show how to replace a headlight globe on a Holden Commodore VF 2015 model.

Thanks to everyone who watches my videos, Likes, Shares and or leaves a comment. I appreciate everyone of you.
I have included below links to buy the bulbs online



Disclaimer:
GerardBurke is a qualified motor technician who has completed modules & courses in manual handling and all aspects of workshop safety. These videos are not intended to be used by anyone who is not trained and or qualified to carry them out.
Due to factors beyond the control of GerardBurke, I cannot guarantee against improper use or unauthorized modifications of this information. GerardBurke assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. GerardBurke recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of GerardBurke, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not GerardBurke.

How to replace a headlamp headlight bulb
how to change a head light globe h7
how to replace a low beam bulb
how to change a dipped beam globe bulb

#DIY #HowTo #HeadlampBulb 2014 2015 2016 2017 2018 2019

[Wayneh]

2024 and boy did this video help. It’s the only bloody globe thats twice gone in all the years I’ve had it. Least u saved me some good money this time so thankyou.

[neilflottmann]

Just changed the driver's side low beam bulb on my VF series II SSV Redline. Went in through the wheeel well as per your second method as the engine bay on the V8 is jam packed with stuff and I didn't think there was any chance of getting to it from above. Getting the stone cover far enough out of the way was tricky and even then it was really difficult to see to unhook the clip. Finally got it done. The frustration was immense but cheaper than the hour's labour I would have been charged at the garage. Thank God these bulbs only blow every six to seven years! I really think it is a design flaw that you have to go to these lengths to change a b****y light bulb! Thanks for your video, it really did help.

[MekazaBitrusty]

Thank you for the video. You were the only one that shows the clip and how to get it out of the way. 👍👍👍

[susabrown]

Thanks a lot mate, as a nurse on a Sunday off, you saved the day. But I have to admit it took longer to get the bloody airbox box back in than anything lol cheers

[danielbuck]

Thank you great video. Just changed my light using this video. Very easy took me 15 minutes.

[solidostso]

I was just taking it out without removing anything cause i didn't have the tools lol but good to watch cheers !

[Rookie]

Cheers mate! Tried your way, couldn't remove the lower part of the airbox, kept fouling against other parts. Ended up going with your second suggestion. Thanks for the helpful video!

[anthonymorris]

Thanks for the video mate. Just helped me change it. Took about 25 mins as I don’t have the exact right tools (open spanner set for the air box nuts).

[ianmoone]

After doing it this way, I found out there’s a much easier simpler quicker way to do it.
Remove clips & front tray, twist washer bottle spout & it and the lid / washer dip stick comes out with a 180 degree twist.
Then the air inlet elbow just pops out, & easy access to rear of globe.
No need to remove air box etc at all. 👍

[miketruong]

Thanks for taking the time to put this instructional video together. Very helpful, cheers.

[chrisakadogman]

Cheers for the vid bro, I figured it had something to do with that metal clip.

[Nathan-gmlg]

Thank you so much this video helped so much with my GTS! Not all hero’s where capes hahaha

[mattmallick]

Thanks for the help mate! No other video showed the clip!

[CamboRoss]

I went the of removing the wheel and inner guard off, found that easier. But thankyou so much for your help, the driver's manual wasn't much help!

[alracm]

Great video. Very straight forward explanations. Thanks for sharing your knowledge!

[craigjosling]

Thank you so much for this video. It helped me a lot.

[lei]

Thank you for making this video 👏🏾👏🏾 Very useful

[patkelly]

One of the nicer ones Gerard, When the air box is removed:):)

[stephenpaynter]

Thank you. I am about to do this replacement of both lamps.

[azadpedia]

Fantastic, very helpful, saved me some money.