10 bolt chevy fast axle removal

[henrye]

How does this man not have more subscribers. So versatile and so much knowledge and he's sharing it for free.

[EdgeofEternityBillCameron]

I looked for the best 10 bolt rear end video and this one popped up!!! Awesome Arco!!!

[carportmods]

Push the axles in from both sides and the C clips will fall inside the housing. The axles will easily pull out after that. Replace the c clips upon reinstall

[rickhammar]

I just changed the rear end in my truck because that 5/16 bolt that holds that pin that holds spider gears in broke off. Boy did that suck.

[KensStuff]

I"m not trying to be a know it all. but that diff didn't have C clips inside holding the axles like a 12 does. you didn't need to pull the cover or the cross pin to get the axles out. still a good video. l like that slid hammer it's a beast.

[whoiswaynereynolds]

What's that puller called again? The big Joey? 😂

[lucyh]

Nice and simple. I wonder if a big ass prybar will do the same on a stuck axle

[budsodalsky]

No C clips? I thought the trademark of GM was those C clips!

[stewoe]

You left out an important detail. This rear end, as you said, is from an Oldsmobile chassis. Buick and Olds 8.5's are different from Chevy's, as they aren't retained with C-clips. Therefore the removal procedure will be very different on a Chevy.

[miguelreyes]

What if the pin is stuck and doesn’t want to slide out after taking the 5/16 bolt off ? 1:55

[moniquesanchez]

Hi I have a 70 Monte Carlo. I am looking for new axels and I want to confirm they aren’t c clip type?

[johnnylom]

I use a magnet to pull the pin out Works everytime

[benjamintaylor]

Would you have the info on where I can find those longer wheel studs?

[brianferris]

🌲🦅🌲 Thank you for posting your video have a safe healthy day 🌲

[markt]

I made something way easy large bolt approximately 1 1/2 inches long, try to make this as long as you can. with three nuts on it two that are locked in place and one with washers in front of it big enough to go against the spider gears then holding the lock nuts in rotating the night against the washers in between the center of the two axles and by pushing up against the spider gear it will push out one of the axles then just reverse it and do the other one against the opposite spider gear this is the easiest and safest way I know!

[moparnut]

How is axle bearing end play adjusted on this rear or is it non adjustable?

[petesmodelcarcustoms]

5 a. m. My time. When this went out. So I must be about 100th again😩. Was there any obvious damage to the spline lands or excessive wear anywhere? 🤔Arco.

[frekkledipped]

so you only have 1 axle? Not posi? I have posi and looking to how remove both

[mitchaellll]

Painful
Push axle in, spin, & pull it out don't have to pull 4 backing plate bolts to do an axle....smh