10 Casocde CS Amplifier with current source load using PDM | Cadence | Simulation| gpdk180 |Tutorial

preview_player
Показать описание
In this video we'll learn about design of cascode common source amplifier with pmos current source load using potential division method ( PDM ) and find out Gain Av using ac analysis, and then perform transient analysis. Also we'll find out the proper sizing of W and L.

Check out full playlist link for Analog IC design videos using cadence

#aicd #rvce
  1. VLSI For Rookies
  2. electronics
  3. gate
  4. exam
  5. self
  6. study
Рекомендации по теме
10 Casocde CS 0:23:06

10 Casocde CS Amplifier with current source load using PDM | Cadence | Simulation| gpdk180 |Tutorial

Cascode Amplifier using 0:23:44

Cascode Amplifier using MOSFET Explained (Cascode Amplifier with Cascode Current Source)

11 Triple Casocde 0:16:44

11 Triple Casocde CS Amplifier with current source load using PDM | Cadence | Simulation | Tutorial

Cascode NMOS CS 0:02:57

Cascode NMOS CS Amplifier

MOSFET Common Source 0:21:55

MOSFET Common Source Amplifier - Small Signal Analysis ( Voltage Divider Bias )

CS-CG cascode amplifier 0:27:29

CS-CG cascode amplifier DC & mid-band gain analysis & simulation using LTspice

Lecture 10 CS 0:45:20

Lecture 10 CS Amplifier with degeneration body effect | Unit 1

Razavi Electronics2 Lec3: 0:46:09

Razavi Electronics2 Lec3: MOS and Bipolar Cascode Amplifiers

Cascode Common Source 0:18:03

Cascode Common Source Amplifier Analysis in Cadence.

MOSFET Common Source 0:18:31

MOSFET Common Source Amplifier

Common Source Amplifier 0:38:48

Common Source Amplifier and MOSFET Biasing

MOSFET- High Gain 0:18:20

MOSFET- High Gain Differential Amplifier (Cascode Differential Amplifier) Explained

MOSFET- Cascode Amplifier 0:05:44

MOSFET- Cascode Amplifier | Quiz # 320

Lecture11: Swing limitations 1:13:03

Lecture11: Swing limitations and maximum gain in a common source amplifier; Intro to cascode stage

MOSFET (Common Source 0:12:26

MOSFET (Common Source Amplifier) with Active Load Explained

Common source amplifier 0:14:17

Common source amplifier | without source resistor | MOS Transistor | VLSI | Lec-64

Cascode (CS-CG) Amplifier 0:11:04

Cascode (CS-CG) Amplifier (LT Spice simulation)

MOSFET Amplifiers - 0:30:01

MOSFET Amplifiers - 01 Common Source Amplifier with Degeneration

MOSFET - Common 0:09:44

MOSFET - Common Source Amplifier (Drain Feedback Bias) | Quiz # 313

MOSFET cascode amplifier 0:16:37

MOSFET cascode amplifier

124N. (Pt. 2) 0:38:33

124N. (Pt. 2) MOS amplifier stages: common-drain, common-gate, cascade, increasing the gain

CASCODE AMPLIFIER USING 0:04:46

CASCODE AMPLIFIER USING LTSPICE

MOSFET: Common Source 0:08:21

MOSFET: Common Source Amplifier with current source as load

COMMON SOURCE AMPLIFIER 0:04:33

COMMON SOURCE AMPLIFIER WITH DIODE CONNECTED LOAD

Комментарии
Автор

Bundle of Thanks dear Waqar bhatt for making such a great tutorials, enjoying your video series. ❤

Renmosheraza
Автор

good morning sir ..good explanation Thankyou....can post lecture on latch comparator design and 2:1, 4:1 MUX

banothkrishna
Автор

Hello im thankfull for you videos. I have a question. whenever I do a DC anaysis and print operating points to find the vth of the first M1 my vth is differente from when I did the analysis with a drain voltage of .9v. When i did for this experiment with a drain voltage of .45v from my DC operating point i have a differente VTH but i see that you use the same vth for both NMOS and both PMOS would care to explain why? or is it that the change is so little that it doesnt matter?

diegomunoz