Introduction to 3 Channel ESC Servo Tester RJX-385

I will reply to all Subscriber's 🔔 questions. So make sure to Subscribe.😊
Please like 👍 the video and type simple word in the comment. It helps me a lot.

This video introduces the 3 channel ESC servo tester by RoboJax

*** Purchase Arduino Start Kit ***

****** Purchase Authentic Arduino Uno from ****

****************************
****************************

Want to learn Arduino step by by step in structured course?

I need your help. I appreciate it.
Please subscribe to my other channel

For our Arduino Library, Arduino Codes please visit

[martinj]

I have just spent all evening trying to work out my speed controller fault! Then found this great tutorial. You have made my evening Thank you 🙏🚁

[serseri]

Hey Robojax, we meet again, love you bro, good work as always, maaşallah, selamun aleykum

[pepoxone]

Great teacher! Thanks a lot. now is clear for me how ESC/Servo works.

[aligator]

Thank you for nice video.finally i andanstanding fulli conections .You have a talent to eksplaining good.Pleace continu

[timothyporter]

Thanks for the video. I didn't want to risk connecting anything without some instructions.

[francescoranchi]

does the servo tester need to be calibrated? is the maximum value on the servo tester's potentiometer the maximum speed/rpm that the motor can spin?

[iskatoysen]

finally full picture of all connections, now it's clear how to repeat this, thanks!

[davidbolha]

Heey,

Liked. ☺

This information will come in handy when I'll be testing a bunch of my extracted HDD BLDC servo motors in the near future. 😊

[garyvale]

helpful video !!!! I was unsure if I was able to use my 3S 2200 mAh LiPo to test my servos with, because the tester states 4.0v - 6.0v if I understand correctly, as long as I connect the higher voltage LiPo battery through the ESC, ( and connect the signal wire to the OUTPUT side only ) it's OK...correct?....thanks

[k_bermdeddy]

is it after using servo testing, esc is calibrated again with RX TX?

[merlynrodrigues]

I have connected my 3cell battery to the servo tester, motor, ESC, the light comes on 'man' and when rotation of the nob, nothing moves, please advise

[XXBearcat]

Is there a way to input signal through the ubec from a toggle switch ?

[newton]

can i connect a servo tester to a brushed ESC and use it to turn a brushed motor forward and reverse?

[furulevi]

What about an Opto ESC that has no BEC inside, at 2:15 tha t cable has only 2 wires instead of 3.

[techguna]

Bro in my esc when I power it up the notification sound was not comming bro but the esc working plz tell the solutation bro plz 😭😭😭😭

[srinivasanm]

Can we use the same servo tester For 150cc dc brushless motor ? Pls suggest

[hyluntk]

good day sir can i ask what is the value of the 6 pin ic on that board? thank you and very nice tutorials

[tomtouma]

My ESC puts out 3.3V. Won't work with these testers. You seen this problem before?

[drewdrew]

What is needed to program the esc? I want to use one of these without a receiver

[parmveergill]

Hello, I'm using a HobbyKing 30A UBEC ESC that needs to be calibrated, i made a calibration code in python but my DT700 motor does not run accordingly, I just bought your servo tester but do you recommend any other way to calibrate an ESC? I'm really confused and have my project due in few days. Please help! Thanks