2.3.1.5 Packet Tracer - Configure Layer 3 Switching and inter VLAN Routing

This video shows the Packet tracer activity Configure Layer 3 switching and inter VLAN Routing.

[nasser_omar]

Your video is really simple and easy to understand, but all the explained steps were on the MLS switch, but what about the other switches !!! I think knowing their actual configuration is an important point too !!!

[williesolomon]

Yes a very clear Tutorial. Thank you for sharing and God bless.

[davidkain]

Thank you again. Finally an easy one :)

[michaelthedriver]

i only got 1 directly connected network in routing table, I did everything exactly the way u did.

[ACBHeeK]

thank you bro, only i m bored with that native vlan mismatch info message on CLI, hahah, i don't know why it appears

[maryamabdulbaseer]

i need help in a design .i have 3 switches with 2 vlans in each ..and the swithes are then connected to switch 4 and SW4 is then connected to router and a vlan that contains 3 servers.can someone help me configure that design

[Hero]

my MLS is not populating the Routing Table after inputting IP Routing command

[jaelski]

I don't understand (noobie). You can ping the cloud in MLS. You didn't even show the configuration on that. (The clustered cloud thingy).

[mrhatia]

hello, how to connect switches with pc and mls etc .. if u have video, send the link plz... how to make this whole diagram, before starting lab....

[milanantonic]

Hi, what is the message of MLS router (%CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet0/1 (1), with S1 GigabitEthernet0/1 (999).) Thanks