The Deployment of IP PBX & IP Phones in Local Area Network

preview_player
Показать описание
How to deploy an IP PBX together with an IP phone, and a SIP trunk in the #LAN? - This is the FAQ from many of our end users.

Therefore, in this video, we’ll walk you through the deployment of IP-based devices to build up a #VoIP telephone system in the office. We will make use of the following devices: a switch connected to the local router, a Yeastar S300 VoIP PBX, a Yealink IP phone, and a laptop for configuring all these devices.

—————————————

*Chapters*

00:00 IP PBX in LAN
00:18 What is LAN?
01:18 Task 1: Set the network interface of the device.
03:15 Task 2: Connect the LAN port of the #PBX to the switch, and connect the laptop to the switch.
03:44 Step 1: Connect the IP phone and switch with the port internet
03:55 Step 2: Configure the SIP dedicated trunk on Yeastar PBX
05:21 Step 3: Connect the network cable to the WAN port of PBX
05:28 Step 4: Configure the static route on the PBX
Last but not least: Reboot the PBX to make all configurations work.

—————————————

Рекомендации по теме
Комментарии
Автор

this is the eye-opening video for beginner.

bharat
Автор

Thank you for the valuable information

muhammadasifkhan
Автор

Thank you @yeastar this video is very informative, my question is will the SIP and IP phones work in LAN environment without internet?

laminsanyang
Автор

Thank you for this video. What about the configuration when we we have one either net cable for both voice and internet. What will be the configuration in the IPPBX and the router if required. Regards.

sayiedalial-darwaish
Автор

hi, good to see yeaster .
could you please tell me if i want to teminate the calls from another country to this ip and going to end user is it posible ?

hybridcar
Автор

Hello can this phone get the IP address without me configuring it cuz i want to use it as plug and play in the network where it receives ip address over dhcp . And the ont do registering for the IMS not IP Phone is it possible?

tarekmostafa
Автор

Hola tengo una s100 con teléfonos T19P E2 y T21P E2.
Los T19P E2 funcionan de maravilla inclusive a más de 90 metros de distancia en cable.
Pero los T21P E2 solo funcionan con un cable de red a 5 o 10 metros de longitud. Si sobrepasó esa distancia el teléfono enciende pero no da IP. Y muestra el error "RED NO DISPONIBLE". alguna sugerencia? Será que estoy haciendo algo mal.?

orlandosantana
Автор

Why DNS to 192.168.1.1 and not 192.168.6.1?

MetallixX