EVPN-VXLAN Config Build From Scratch 1

🏗 How to build an EVPN-VXLAN from scratch using Aruba AOS-CX devices.
🦴This is a near live presentation over two parts that takes a bare bones config and shows you the configuration of an EVPN-VXLAN network for inter-subnet traffic flows.
👉In Part 1 we cover the underlay config, and prove it with static VXLAN before configuring EVPN for L2VNI (intra-subnet)traffic.
🚀In Part 2 we will configure asymmetrical and symmetrical IRB for Layer 3 routing.

⏰Time stamps
00:00 Intro
01:04 Network design
03:55 Underlay configuration - VLANs, IP addressing, and OSPF
07:40 Static VXLAN - three VTEPs and two VNIs
12:30 Sending test traffic & viewing MAC tables
21:50 EVPN configuration for L2VNI - BGP peers and address-families
26:55 Viewing BGP EVPN sessions
28:00 EVPN specific config
31:00 The BGP EVPN tables - RT-3s
38:00 Generating RT-2s and viewing the EVPN tables
40:40 Viewing RT-2s in the BGP EVPN table

More info:

[georgemavimbela]

This is very very very informative and clear to understand thank you so much.

[patrickcasavant-cssmv]

Big thanks to you Joe! As always, verry well explained, you make it easy to understand! Love your Video's! 👍

[simonespinedi]

Without the labels of the interfaces in the draw it is complicated to understand to which trunk interfaces you allowed vlans 2010 and 2011 but mostly vlans 10, 20... you applied for vlans only on 2 interfaces, 1/1/10 and 1/1/20... which of those are for the customer side? and which for the vteps? i'm getting lost...

[simonespinedi]

The interfaces where clients are attached are in access or in trunk?

[rasheednazar]

Is your channel sponsored by Aruba to work with Aruba devices only. Anyways nice tuts. can get some idea though!

[simonespinedi]

I'm trying to replicate this lab, i struggling with the ospf adjacency... it forms neighborship correctly only between vtep 1 to vtep 3 on vlan 2011 and between vtep 2 to vtep 3 on vlan 2012, not between vtep1 and vtep 2 on vlan 2010... Configuration is the same as you did, don't know what to troubleshoot... Trunk on interfaces allow the vlan 2010, and with sh mac-address i can see the mac address of the vtep2 from vtep1, but i can't ping between 10.0.0.0 and 10.0.0.1

Could be a bug?

[RishiRap]

Command line too small to see. Useless.