VMP Gen2R TVS vs. VMP Gen3 TVS 2017 Ford F-150 Dyno Pull

Joe Goodnough's 2017 Ford F-150 may look like your typically daily driver, but it's anything but.

See how much horsepower the truck gains when swapping from a VMP Gen2R TVS on 93 octane to a VMP Gen3 TVS with Dynatech Long Tube Headers on C16 race fuel.

Mods on the car include:
✪ VMP Twinjet 67 mm TB (included in F-150 Stage 3 supercharger kit)
✪ VP C16 Race fuel
✪ Dynatech Long tube headers
✪ Belltech 1000SP lowering kit
✪ Calvert Caltracs
✪ Bilstein Rear shocks

------------------------------------------

Our live shows are now available in MP3 format!

Have ideas for future shows? Let us know in the comments below!

------------------------------------------

Have you seen our shows?

Tune in each week for:
✪Tuning Tuesday | Tuesdays at 1:30 PM EDT ✪Burnout Box | Thursdays at 6 PM EDT

-------------------------------------------

[VMPPerformanceTV]

Hey everyone! We'll announce our winner of the swag bag tomorrow at noon! Make sure to like, share, and subscribe!

[flooringmann]

Tuning Tuesday love you guys tune in weekly to both shows lots of love and support from southern Illinois

[adrianbrown]

I’d like to see to comparing numbers from a 2.9 Whipple with 2.75 pulley just for Curiosity on same vehicle

[peterscott]

Excellent vid . I have a 2016 f150 5.0 and i have a chance to get a vmp 2r from a 2015 mustang GT aside from some vacuum is the lower intake the same an will it bolt up to my 2016 f150 5.0 if not what lower intake do I need Thanks …

[freak_.]

So basically a 50whp gain. I'm pretty sure the Gen 2R would have done 650whp with the longtubes and C16.

[NITROUSnBIASPLYS]

Tuning Tuesday yeah buddy!! Best show on YouTube 😎👌🏼

[jesusleon]

Sounds a lot like a 6.0 LS2 in the TBSS 1:38

[Swhipple]

Check out tuning Tuesdays great content. Nice job Joe

[Romeaaro]

Where the hell y'all find a f150 single cab with a 5.0 in it

[marcozr]

is it just me or dis the gen2r rev faster

[jessaphillips]

waiting patiently for the install video for AutoVlog's Supercharger

[builtforspeed]

Hey guys I just wanna ask does the gen3 coyote from the mustang and gen3 coyote for the f150 has the same crank? I just wanna know if the crank pulley are the same diameter

[csr]

Nice! Could you guys please leave out the music at least when the truck is running/doing a pull on the dyno?

[brianneal]

TUNING TUESDAY. Hey, on your live videos, be sure to remind them about clicking the bell icon to get notices when new videos post up and when live videos start.

[whiteandnerdytuba]

Can y'all finance through dealers with purchase of new truck

[Liftnwts]

I am still on the fence on what blower to get Roush, Gen 2 or Gen 3 R. IMHO you guys should have installed headers and retuned and got some numbers with 93 then with race gas. then installed the Gen 3R and got some 93 numbers.

[jpcs]

And now it’s time to replace the Factory oil pump gears before they come apart!

[manowar]

I'm assuming this was at similar boost, but for a swap of 3 parts that's an impressive upgrade.

[jaysoto]

Go ahead and send me the gen 2r you guys took off!

[randysrestoration]

how much power do the headers actually add at this power? Gen3 vs Whipple? close to same power? Oil Pump been upgraded? 10.41 @ 131 with small tires is really haulin' the Mail! I think its time to retire my 482" FE Dinosaur and make some real power at a fraction of the cost!