DIY CNC - UCCNC first test run. 50mm square to test CV settings

A test run of the newly installed UCCNC control software. I'm using a UC100 motion control with this. Programmed a 50mm square 6MM deep feeding @ 2540mm/min & ramping 20mm long @ 1250mm/min. RPM=14000
Very happy with initial results as it measures spot on with sharp square corners.
I won't be going back to Mach3, I'd be guessing.

[chrisinestes]

It'll be interesting to see how you like UCCNC over time. I use Mach3, and it works for me, but I don't even begin to understand how it works, and how to make it work better... Assuming it could work better for me.