BIGTREETECH SKR Mini E3 V3.0 Unboxing

This board was purchased by myself - not a sponsored video.

[LuisRodriguez-]

Congrats, your the first to review this.

[GERGE_GERGE]

hello.
which board is better for Ender 3 Pro BIGTREETECH SKR Mini E3 V3.0 / BIGTREETECH E3 RRF V1.1 / BIGTREETECH BTT SKR Mini E3 V2 ?

[EnochPedersen]

Thanks for the video! Do you think this would be worth installing on a Voxelab Aquila?

[danielrdugan]

Great video!! Would love to see a side by side comparison of what the V3 offers over the V2

[mgonsalves]

Have you successfully installed this yet? I’m a bit lost on the fact that this new board appears to be missing two of the screws, bottom left section, that were on the previous board. Not sure where these cables go. I was expecting a simple 1-1 drop-in replacement like the last version.

[edlightenme]

Is this new board silent? Like will it eliminate the beeping noise when printing?

[kapibara]

What do you recommend for a beginner SKR mini E3 v2 or v3? Which board is easier to install?I'm just facing a choice between these two boards...Tell me please. Sorry for the mistakes, I'm from Russia, translated through Google translator.

[Pickle]

First video I've found on the new version, do you think the upgrades are well worth it? Main difference is the heatsink change and additional Z motor output correct?

[cristimihai]

what is the stl of the voron fan duct? i see that it is direct drive too

[alexander_kartsev]

The name of the chip is TMC2209, not TsMC2209

[Specialedes]

Im having a hard time trying to figure out how to set up sensorless homing with klipper do i have to set a specific diag pin like ^PC0? The jumper on the board has no specific pin it just says diag