iNav Flickering & Dissapearing OSD with solution

I solved my flickering OSD problem by using 1.13mm Mini Coax, the video runs through the centre core while the ground runs through the shield.
In this MiniRaceWing an Omnibus F4 Pro flight controller is used. The grounds (going over the shield of the cable) is connected to the AGND pad next to the video IN/OUT pads. Both between cam-OSD and OSD-VTX a 1.13mm coax is used. Both cam and VTX have the regular power wire coming from their power source (in my case a power distribution board, an extra regular GND wire was connected between the AGND pads on the FC and the PDB).
This wire is the same as most simple 2.4GHz wire antennas.
Only downside is the coax isn't as flexible as regular wires and custom connectors might need to be made.
As a first try shorter and direct GND & Video wires could be used between cam-FC and FC-VTX. This is usually the suggested solution in fora but in my case this did not solve my problem, using coax, as seen in the video, does.

[Aaronsbugs]

Is this still working well for you? In about to chop up some 2.4ghz whips.