Replace Idle Control Valve on 2005 Hyundai Santa Fe 2.7L

I show where the idle control valve is and how to change it on my 2005 Hyundai Santa Fe 2.7L.

[HammerHeadGarage]

Just blow off the debris with compressed air before you remove the oil fill cap. You should disconnect the negative terminal from the battery anytime you work on the engine. good video. It didn, t start because you are suppose to turn the key to the on position before you crank. You do this to pressurize the fuel system (fuel pump should run then stop).

[bugout]

Nice video I checked mine it was cracked runs like a champ now thanx

[scottfree]

Did it actually throw a code for the problem? I'm having an issue with the first start after it sits overnight like it doesn't wanna start but once I get going it runs fine. I just replaced the ignition coil and the only other thing I've noticed is it's idling a bit higher than normal in park and the chk engine light is still on? What issues caused you to determine that was the problem?

[daniellewhiddon]

hi, I have a 2005 Hyaundai Sante fe 3.5 L and the car jumps when you come to a stop is this why you changed this or could you help me on why it's doing it?

[proanswers]

why did you change the IAC what test was preformed that it was at fault?

[WorldWideMediaGroup]

mine is having very high idle at 5000 rpms at start up says cylinder misfire for 1 and 4 what cause that for 3.5 tho

[ssmith]

I have this same engine on a 2006 KIa Sportage, and the idle has suddenly began searching between 500 and 1000, back and forth. I am leaning toward changing this ICV like you did, but there is a small chance it could be the throttle position sensor too I guess. What were your symptoms?

[ronnyc]

Where you having any engine trouble that you changed that? A friend of mine has the same car and his engine doesn't rev up when he steps on the gas, it's a pain to drive. He isn't get any check engine light though.

[darrellpatterson]

Before you changed that part did your jeep cut off sometime when running & also idel up when in park and running....when it cut off you have to try a crank it up about 5 or 6 time before it starts back up...I have the same exact jeep you worked on model & every thing & that's the problem it's having...it only do it sometimes

[roccozarcone]

I have to put the camera more closer so people can see hello

[yugo]

mine stalls when idle. what will be the
problem

[Patrick-yhyd]

I might remove then spray and return first. If that does not work I will replace.

[abrahamchiapas]

I think most of us we didn't see what part u cleaned..you removed something. Didn't show.what it was..