1964 - 1967 Chevelle GM A-Body Wilwood Front Disc Brake Install

Detailing the set-up and install of Wilwood's 67 Chevelle Front Disc Brake Kit.

Wilwood Part #: 140-10996-DR

Music | "Sweet" by LiQWYD

[d.rayowens]

BEST at showing full install with numbers and torque. Thors hammer though, seemed overkill, haha

[mgsrx]

Be sure to check your valve stems for clearance if they are inside the wheel. There are low-profile stems available.

[sgvrodmuscle]

Glad I found your video
I’m in the middle of the install, says on the manual you can install the caliper on the front or rear, any reason you installed it on the front?
Also my spindle had a gasket not sure if I should put it back on since the backing plate is not there
(I think that’s what it’s called) awesome video I don’t think you left anything out!

[devicetrickz]

Where did you get the suspension kit with the spindle and everything I'm looking to get my front suspension set up with control arms before installing this kit

[LesleyStoddard]

What spec master cylinder bore size etc ?

[Macnificent_]

Did you run a washer and shim you front of the bolt ??? If so did that help with the spacing for the brake pads????

[lawrencer]

those look like the rear calipers not the front set. is that right?

[Macnificent_]

Great video bro very detail i love it ? Did you have the cut the spindle due to i think i might have the cut mine 78 inpala landeu

[Macnificent_]

Did you run the same stud or did you go longer???

[Macnificent_]

Did yo have to Modify the spindle great video I have the same set up I wish I could find a video for my b body

[Macnificent_]

One pad had a lil play on 1 side is that going to be a issues for me and when i add more shim to fill the gap the other was tight but here the thing they go in nice i just have a lil play

[timvincent]

calliper bracket on the wrong side ? and bleeders need to go up, caliper on the rear side towards the back

[jameshamley]

What is the part number for the hole kit thank you

[dewaynemitchell]

Hello im doing the same exact set-up got a quick question do you use red or blue loctite for each set up such as the bolts for the hub as well as the adapter plate and rotor

[ezy_e]

Nice video but man 😢 did them backwards