How To || Team Associated Slipper Clutch Setup || Enzo Albertoni

Hey everyone!

I’m back with a quick “How to” video, this time on slipper clutch setup. Most of this is how I normally setup my 2wd Mod Buggy at most of the tracks I’ll go to, along with using the same mentality in the 2wd Mod SCT & 2wd Mod Stadium Truck classes.

I hope this video was informative! See everyone soon!

[islandrc-duke]

great information and setup, awesome rc

[Joe_Jenkins]

Just found your channel, good videos. I was wondering the proper way to set this thing, I’m just now starting to get into 2wd

[tylercurry]

What happens if your engine starts making noises when you're starting to adjust your slipper clutch

[dirtrider]

4:34 theres a GIANT difference between locking the rear tires and giving it gas vs driving it. a lot of that power thats going into lifting the front end will be used to propel the car forward. by locking the rear wheels all the motors power is going into trying to lift the front tires.

[freerangehuman]

What brand pit set up board is that your using?

[nutznews]

Where can I find those tyres, what size are they

[HL-OOI]

I try to tightened the nut slightly pass flush but it also turn the slipper pads/hubs while holding the spur..is that already the max?

[tagrc]

Do slipper pads require break-in for best consistency? I have been told that with new slipper and pads, you should tighten the nut all the way down, and leave it like that for 15 minutes to break in the spring. Then loosen it up enough to where it's slip while holding the tires. And then run the car on bench (while holding the tires for a few minutes to build a good amount of heat in the pads to where there is a near mirror finish on the pads. Is this method legit?

[dirtrider]

could you do this the same with a 4wd car if you had the front tires hanging off the end of the table?

[newo]

whats your opinion on the slipper eliminator for stock. I run on a med. to high grip track and Im not sure if I should pick one up

[dirtrider]

My instinct and logic says if your running a mod motor you would want to tighten the slipper. Why do you say loosen?

Well i see you dpnt reply to any questions so hopefully someone else can answer this