New AutoZero Touch Plate from SienciLabs

The New AutoZero Touch Plate from SienciLabs
I am very excited to be able to share this Short review of the NEW SienciLabs AutoZero Touch Plate with all of you!
Learn more about the Sienci Labs AUTOZERO Touch Plate and help support my channel by clicking on any of the links below:
Buy The AutoZero Here:
Learn more about the AutoZero Here:
CAM Software: Sienci Labs gSender:
Router: Makita RTO701C Set at #3 speed
Tools used:
PRE ORDER YOUR MK2 LONGMILL HERE:

00:00 Intro and Unbox
03:27 Plug in and connect to the Longboard
03:44 Thanking Our Sponsor
04:17 Testing begins with V-Bit
05:10 Setting gSender Settings
9:10 Testing Ball Nose Bit
12:55 A Key Tip on material setup
13:20 Testing a Tapered Ball end Bit
14:45 Testing a Flat straight sided end mill
16:44 Testing Z Only on Straight Bit
17:30 Finishing up and How to Order

Facebook:
@BuckyGivesADam
Instagram:

[CaptainYakima]

Just commenting in case it helps others. I didn't see "tip" listed in the drop down menu until I hit the x. After that auto and tip were listed.
The first time I used this plate was with the the 3/8" groovee jenny, the bit was placed so the outer diameter was at the corner. I think this setting will put the tip right on the corner. Thanks Bucky.

[Hinkleshop]

Awesome new probe Dana a tremendous upgrade for zeroing in bits and
I am the first like on your video keep up the great work brother!!

[steved]

Thanks for the video on the new touch plate. Very cool!

[JackInTheShop]

I just starting using my touch probe. Now I might have to get this one.

[dangoras]

Awesome probe.... I would buy one if it would fit my machine.... Keep it up brother...

[iwannaapple]

So, would you mind describing how would you set irregular bits before you got the auto zero. I know how I do it but I don't know if I'm doing it correctly but however while I'm watching that touch plate I see now what I need to to do differently.

[thomasbrennan]

How do you use the touch plate on the upper left or right corners to set your starting point of the project in G sender. I tried it on the upper left corner and it bent my bit because it traveled as if it was positioned in the lower left corner. I don't see any setting in the software to change the home position like you can in Vcarve.

[rickgauthier]

Great video, thanks. I wonder why they had it made so thick. I don't normally like to protrude my vbits that far out of the collet. It just seems to be to thick, they could of still done this design but a bit thinner. It just looks crowded in the throat of the a side note I did change my order of my 48x30 mk2 to swap out from the og probe to this one. Just wish it would come to me sooner then July lol.

[josephlanglois]

can the reg touch plate be used with any machine