Mercedes benz c230 kompressor all keys lost w209

All keys lost on w209 benz EIS system. Using Autel MaxiIm 508 with xp400 . Pulled password under smart mode/fastmode(gbox). With wifi. 2005 c230 kompressor. On Autel says use fuse 29 its actually fuse 52(5amp) underwood junction box for the relay fuse on gbox. K-line plugged into pin one on steering lock connector. Took 13 mins to calculate password. After calculation proceeded to write key. After writing key connected steering lock and put fuse #52 back then disconnected autel and tried starting car and key successfully added and started vehicle. Highly recommend Gbox2. Without gbox can take up to 8 hours just to pull password. Tried for 2 hours without gbox and no luck. Def worth the investment.

[mohanedhurani]

Thanks bro, a tip for everyone doing AKL. If you dont hear the ticking noise very often, then youve most likely got the wrong fuse locaiton. You should hear the ticking noise 29 or more times per minute for gbox fast. If you hear it 14 times per minute, youve got the wrong fuse

[fastlocksmith]

Hi man how did you figure out the fuse because the diagram in the autel is wrong can you explain to me please you helped me this time a lot i got stack on the w209 couldn’t find the fuse then see this video 20 min job and i was done. Thank you

[jonathans]

Hey bud, what's your thoughts on the IM508..? I hear mixed things compared to Autel big brother 608. The 508 seems very healthy to me. Great video. Thanks, Jon

[keyinminutes]

Hello friend…one question. I just tried AKL on 2008 CLk550 (W209 as well) and could not get it to calculate password. About 3 mins in, it would as “Failed to obtain data” when calculating the password. It would obtain EIS data fine.

I noticed you essentially had the EIS laying in the floor. I was not able to get it out by dropping the bottom panel and then lowering it down through the bottom. What is your secret to getting it out?

Any help would be greatly appreciated!! Thanks in advance for any assistance!!

[starautolocksmith]

Great video but you didn't show us how you did it. I did it on bench took me 5 minutes to get password with autel MI608 and I think Autel MI 608 is best scanner out there.

[imasngoi]

Holy shit better off doing it with PROG if your having to do all that.. tops 8 min and you’ll have the EIS FULL EPP, keys files calculated and key programmed.

[waldemarfechtel]

Do it bench don't nee open hole car as you did. Safe your time