Hi MKS. Is it really necessary to connect the yellow wire of the button to the NC contact? I'd like to use a simple two pin button.
sedi_
muy bien explicado todo.. no se puede hacer mejor... Gracias
roberto_
Hello Team Makerbase, the PWC v3 doesn't at the end, I put the auto mode but at the end of the print is there a message like "Print finish - again or confirm' the printer doesn't power of. thank you in advance
Sylmoal
There is a video tutorial to MKS Robin Nano V3 + H43?
CharlieAMiquelin
Will this board turn off the 3d printer in case of printing failure or board freezing?
anonanonim
hello makkerbase, can i install this module for printer Ender-3 v2?
Lunsky
Can this work with a raspberry pi with octoprint?
joselagunas
Hi hou can i connect this if i using a ups mks robin e3d
geraldblindeling
Give a link to the screen theme from the video.
anteyru
doesn't work with Marlin 2. robin nano motherboard 1.2. How do I configure Marlin 2 to run PWC 3 and robin nano in LVCL UI mode?
