Introduction to solidworks flow simulation : cfd analysis of convergent divergent nozzle

Learn how to carry out cfd simulations using solidworks flow simulation module for convergent divergent nozzle.

[esquivel]

The "inner wall" boundary condition suddenly appears @5:59 (around the 6 minute mark). How was this set? Also, How can I view the exiting air? I had a look at the previous comments/answers and I do not understand how to check the "analysis settings" or in better words, what settings to change. Please help :)

[corneesmit]

But how do you simulate what happends when it exits the nozzle

[germangarrido]

That´s an interesting video. Thank you!

[makkihassan]

how to use solidworks flow simulation results as initial boundary conditions to perform anoth flow simulation based upon the results

[reviewvideoes]

when i make the geomatry and opens it in flow simulation the error appears that please make a lid

[jiml]

what is inlet to throat area ratio and exit to throat area ratio of this ?

[eloymartin]

Same problem:
(((
my simulation is in "preparing model" and never ends - why does that happen? thanks!

[ty]

Hello sirs
Pleased to be making the needful

[MsMatheusrichard]

Hydraulic system is about 80 bar, 250 bar is so much!

[Andres-grus]

Fluids simulation with solidworks has no sense