All you need to know about Fuel injector tester kit/Cleaning fuel injectors /AllSun Injector Tester

All you need to know about Fuel injector tester kit before buying it
in this video i show how to use AllSun Injector Tester for Cleaning fuel injectors
AllSun Injector Tester, has four different modes for pulsing the fuel injectors
First three modes stops in a certain time but the 4th one, is a continues pulse
the only thing i didn't like about AllSun Injector Tester, when changing the pulse, you need to disconnect the power and connect again, then you can change the pulse modes
i showed All you need to know about Fuel injector tester kit, if i missed any, lets us know in the comment section bellow

🔔 Hit the bell next to Subscribe so you don't miss a video!

Follow my Instagrams so we can be best friends
-------------------------------------------

Like my facebook page:
-------------------------------------------

**If the video was helpful, remember to give it a "thumbs up" and subscribe and turn the notification bell on, so you dont miss any new videos

Gears I Use:

For contact
Follow me
Instagram: ali_mechh
personal Instagram: alimechh

[sarahdeshay]

I have one and I use a dewalt 12v lithium battery. I soak all of them in sea foam (in a jar) in my ultrasonic cleaner and I connect each one to the tool set on steady pulse for about 10 mins each. I take the o ring off each injector as I disconnect from the power so that I can keep tract of which ones have been run while soaking and cleaning the entire set. The jar allows me to fill the cleaner with only water and after I finish I simply remove the injectors and cover the jar and set it aside for the next time I need it.

[markfitzgerald]

Put an on/off switch on the positive side from battery to reset

[johnc]

Nice video! Straight forward without bs. Thank you!

[Javii]

Question. When you pulled the injector out, was the metal tip extremely gunked up with burnt oil and carbon? Mine look terrible, not sure if that is expected or if i have a failed seal somewhere

[difsid]

how did i not find this channel before, great work man

[Sagemeister]

What size rubber stopper did you use to attach the spary nozzle?

[mirikledragon]

DIY adapter... how you make? I see hose and clamps... what is connected to red hose inside to seal? Thank you

Great job by the way.

[Deposito-uc]

you should install an ox/off switch so to don't disconnect the cable from battery. aniway good job

[JohnDoe-xbov]

How much ohms does Siemens DEKA injectors supposed to be and question what you use to stop the fluid from coming out from the hose when u sprayed it with carb cleaner like how you sealed it so it won't leak

[spindlehospital]

may i use cleaning clean set and pulse device together in my workshop with ultrasonic cleaner ?

[darawan_abdulwahid]

How can I buy one like this, thanks for helping...

[VinSpacker]

Can I just tape down the cleaner nozzle to the open position? Will that be too much pressure?

[kafuna]

Can i use continental diesel injector testing

[chetantikone]

Can it be used for diesel crdi injector ?

[dillanthomas-seiler]

Wait so how did you get the red tube clamped to the rubber hose?

[dasunwimalarathna]

How do you get it? What is the price ?

[damiropadobarglumskiperiod]

If i do nit have tester can i open it wuth a 12 volts

[AbdulSattar-gswm]

How much this is Electronic injector cleaner

[CHEVI]

Just use a momentary switch which is normally closed type, in other words when not pressed it's always on, when you press it switch off.

[crystrezerexlife]

Can you use alcohol or peroxide to rest, instead of carb cleaner?