AUTEL Maxisys How To Code / Programme Gearbox | STEP BY STEP GUIDANCE

Citroen C4 Gearbox Programming Using Autel Maxisys MS908s Pro.

Fault code that was coming up are below.

P1800 - Transmission Programming Not Completed or Not Performed.

P0949 - Clutch Programming Incomplete or Not Performed.

[woodyscreations]

Ive tried the geabrox programming wih diagbox on a C4 grand picasso . its gets stuck at clutch biting point left it tryign to 40 minutes and still stuck there. Any ideas?

[alzhs]

Hi mate changed clutch on a Vw up ASG gearbox with an actuator, but gears are very slow to change and when car is stationary it has quite a bit of vibration

[fazbari]

Hi mate have you had situation where after programming it doesn't shift from 1st in auto, manual mode shifting fault codes, I have programmed it many times, doesn't say it failed gear grid learn or anything . Any advice welcome.

[zeeandmarina]

I have a peugeot 3008 and have this same error when I try to programme the clutch. It gets stuck at clutch biting point with “action in progress” and no progress even after 20minutes. Any idea what could be the cause? Thank you.

[boldoobatbolt]

Hi. I has an Peugeot 508 I just replaced the clutch kit without thrust bearing. And now I couldn’t program the clutch!! Should I need replace the thrust bearing?

[fadilhijazi]

Which battery maintainer do you use for programming?

[aqibfreed]

Will this work on japanese cars also ?? Thank you

[mihaimatusoiu]

Hi.
This is everything you have to do, for example after a clutch replacement ? Gearbox depressurised, parts changed, pressure again the gearbox, and then follow this steps ?

[richardmauto]

I need someone to do mine. It's jaddery too. I am in Rochdale, Lancashire.