QUICK!!! running a Stepper Motor Silently TMC2209 and Arduino

preview_player
Показать описание
Plug in Vs, GND, Vio, GND, enable to ground, step and direction to arduino, and of course the 4 motor pins. I did not power the logic of the TMC2209 with the arduino's 5 volt supply as it will lead to power draw issues when I use multiple 4 units on one board for my upcoming project. Arduino CAN accept 6-20 volts in the DC jack. The driver can accept 4.75-29 volts on the Vs pin. Higher voltage is better for driving DC motors faster.
Accelstepper was used in coding.

#arduinoproject #diy #maker #woodworking #coding #steppermotor #electronics #arduino #breadboard #prototype #robotics #diyprojects #diyproject
Рекомендации по теме
Комментарии
Автор

The TMC2209 doesn’t have an MS3…!? What is the 5V good for then? I am still learning and there ist many confusing information around this

TheMrOcelot
Автор

Bro got the Wire spaghetti and meatballs 😂

bierymolina
Автор

Hello ! You also use uart? I am not able to read/write trough uart and still trying to find out how to use it thx

Denis-wsqe
visit shbcf.ru