Bifold Door Installation

preview_player
Показать описание
This video demonstrates how to install a Bifold door.
Рекомендации по теме
Комментарии
Автор

Helped me too, since the supplier doesn't want me to fix it myself by withholding this info. Great stuff

philgray
Автор

WOO! Thank you! This video helped me fix my bifolding door!

chellsbells
Автор

I just brought these brand of doors with glass to replace solid slab french doors, There is a door stop trim above the opening where the metal strip that came with my new doors will go, Do I need to remove this existing trim. It doesn't seem to be in the way.

jaybatemen
Автор

I can't drill holes in tile floor because I'm in a rental, this video first shows the floor bracket being drilled into, but then they leave out the floor screw and still use it... i wonder if tha'ts okay or if it'll destroy itself over time?

aeonjoeyd
Автор

The track was cut a little short. Also, what about the door snubber placement?

fiendmojitos
Автор

And the installation of the door snugger, that little piece of plastic with a spring running through it, is where ?

markanthony
Автор

Gravity makes it easier to place the bottom pin first, then pop the tops in after.

cjpenning
Автор

MIGHT HELP TO PLACE THE JAMB BRACKET SCREW THAT GOES INTO THE FLOOR. WATCH AS THE DOOR IS PUT IN PLACE AND THE ENTIRE JAMB RISES UP ABOUT A QUARTER INCH. ( NOT GOOD )

TRICK-OR-TREAT
Автор

Does anyone know where i can buy the full set of railing and hinge to make own bi folding table? I am Come from Indonesia as well

fajarwijanarko
Автор

what does the rough open size of the door frame need to be ?

mwhitney
Автор

real nice finish look to bad its wrong - always install trim around the door after to hide the gap between the door & jam

tikimadman
Автор

Necesito 2puertas Me pueden enviar la dirección donde puedo comprarlas

freddyramos
Автор

My doors fell off so Im watching this to find out how to fix them on again

racoonplont
Автор

When I installed the spring pivots into the door the springs no longer push the spindle back up. Dodgy b and q rubbish.

djpywell