HOW TO INSTALL A DIGITAL TEMPERATURE CONTROLLER / RELAY !!

Показать описание

Today i am showing you how to install a digital temperature controller,
These are found on ebay and are cheap and easy to use.

STC-1000

Thanks for watching

Check out and subscribe to my Twitch channel

Extra Tags:
Digital Temperature Controller Thermostat
Digital Temperature Controller for Incubator
Digital Temperature Controller Thermostat for Incubator
Digital Temperature Controller with Probe
Digital Temperature Controller outlet Thermostat
Digital Temperature Controller for Freezer
Digital Temperature Controller for working
Digital Temperature Controller Manual
Digital Temperature Controller Wiring
Digital Temperature Controller Guage
How to install Pid Temperature Controller
How to replace Temperature Controller
How to install Temperature Controller
thermostats
smart thermostat
programmable thermostat
house thermostat
thermostat wires
temperature controller
digital thermostat
relay
temperature relay

Рекомендации по теме

Комментарии

Thank you so much I had obe f those for years inside a drawer and frustrated about not been able to understand how to set it up. Finally, I can get my chicken hatching machine to work to create some life.

George-hlqj

Thanks for the video two thumbs up. Could you help me out setting the controller. What I wish to do is set the controller to open when the temperature reaches 5c and turn off when it reads 3c. How do you know using the setting button on the front which number setting will be open and witch will be closed? The instructions I have don't seem to make it clear

twohulls

So, the relay terminals just function as a switch that would measure zero ohms between them when the relay is engaged? I have the 12 volt model. So, it appears that I would connect both positive and negative 12 volts to the power in, but the relay is just a pass through that could potentially be a different voltage? I have a need to control a pair of 48 volt fans, but I want to use 12 volts for the controller - since, they don't have a 48 volt model. Thanks, for the video!

richardowens

Thanks for the video, nice simple instructions. I am looking at this to switch off two things, a fan and a heating element - am I able to wire in these two components into the one switch?

stefanrusso

Excellent video, except it doesn’t explain how to alter the temperature settings. “mess with them” isn’t sufficient!

Bobharrow

How to install micro-computer controller instructions of STC-8080A+ please ?

ralayghislainjose

Will this work to replace a switch on a portable heater ?

fandechavalones

however- you havent shown where the 2 orange wires were attached to. This was the part I was hoping to see

romandarko

Can i use it for my water heater for my bird fountain? I dont want it to run 24/7 when its above freezing. Please let me know how to set it.

fridakahlua

Will this shut off a portable generator if I hook this up to the low oil shut off ?

DavidD-txgh

Good video. Do you know if I get the 12v version, can I only control 12v devices? And same with 220v, can it control 220v devices? Thanks!

matthmbg

A very informative video, thanks! I have a question about the the current for the attached devices. As the programmed temperature is achieved and the heating (or cooling) circuit is closed: 1) do the output relays just close the heating/cooling circut, no matter what current the heater/cooler uses (3V DC, 220 VAC etc.), or 2) does the controller just "supplies" its "own" current (that is 220 VAC for this version)?

pawel

Here you want the circuit complete when it goes ABOVE a certain temp to activate a cooling mechanism. What if I want it to trigger a heating element when it falls below a certain temp. Can I just reverse the wires on 1&2? I’m so lost! LOL

justlook.productions

Can i use it for 2000w air heater in room ?

Imkerei

Hello sorry to bother you,

So I ordered the 110v model but when it came, the sensor was detached from the device. I'm not familiar with wiring at all so I wasn't even sure if this was normal. I tried asking the seller but they didn't seem to understand. How would I go about attaching it?

Trueshogunate