Filling and Refilling lubricator #simalube with grease

Filling with #grease

1a. Push piston all the way forward by blowing gently with compressed air or with the aid of a plastic rod (7 mm diameter), towards the bottom or opening.

2a. Screw on refill nipple (art. 290.3012) and connect grease gun, or screw connector nipple (art. 290.3013 or 290.3014) onto grease gun. Keep the #dispenser pressed to the adapter during the filling process so that you do not have to screw on the refill nipple again. Press grease into the dispenser. Avoid air bubbles when filling the unit. Continue the filling process until the piston has been pushed all the way back. Do not overfill! Caution: Lever presses can create pressure of up to 80 bar, which is enough to destroy the dispenser.

3a. Use closing nipple (green) if the dispenser is to be stored.

4. Position gas generator (make sure the O-ring is positioned correctly) and attach firmly with a 1.5–2.0 Nm torque key.

5. Clip in cover disk.

6. Note grease type and filling date on the label.

[abdoukheldoun]

Nous avons le même type de tube. Nous l'avons rempli et mis à sa place habituelle, mais le problème était que le liquide ne bougeait pas de sa place avec le temps. Donc le tube ne remplit plus son rôle comme avant