The old carpenter revealed this secret! #shorts

[toddgardner]

To use the "trick" do not forget to put a 1 1/2 inch block under the off screen end of the 2x6. If you don't, the cuts will be off.

[henriquepicelli]

You forgot to show that you need to add the same measure of the height of the bottom wood at the other end. Just cutting this part doesn't work.

[kevinblanchard]

Great way to "trick" someone on cutting birdsmouths so they will not fit.

[SantosWhite-kz]

Thank you for sharing your experience with us all.!! Appreciate it..

[WINEWORKZ]

The only “trick” was that you were able to get me to watch this video

[АлександрМакаров-оли]

Если угол-край доски ту, что пилят стоит на полу, , , т, то угол наклона изменится (геометрия (×=синус альфа умножить на расстояние от угла планки-доски, что торчит из стены до пола в точке соприкосновения стой доской, что пилят

[ricardocastro]

As a builder plz don’t do this as you have to take into consideration ridge height and roof pitch. Learn to use a framing square

[paulwright]

No old carpenter would do this. He would lay out with a framing square. Someone who does not know what he doing would do this. Coming from a OLD CARPENTER 😊

[somatder]

be aware! This is a useless "trick." You need to know the angle/pitch for the roof and use a framing square or speed square to mark the cuts for the bird's mouth's

[Reecegk]

make sure the top of the rafter is sat above the ridge by the same width of the your scribing with

[michaelgarrow]

As and old carpenter; I can guarantee I have never done this… 🙈

[BioMess]

lol... My structural wood teachers at the world class trade school I graduated from with flying colors in 89 are shaking their heads.

[joewoodchuck]

He forgot that the angle changes when the piece is lowered into place. There's a way to do that, but he doesn't know it.
I'm surprised so many people missed that point.

[MountainEagle]

No one ever shows the top portion of the rafter because this will not work here unless you compensate for that portion. Apparently, these so-called carpentry people on YouTube have no clue how to do real carpentry.

[juancgutierrez]

Now teach them how to get a rafter length and how to add the overhang

[paolociravolo]

Complimenti per aver dimostrato questa BELLA idea!!! 👍👍👍👍👍👍👍

[freelonmorris]

My grandpa and Uncle Eddie always knew the pitch and used a framing square.Always worked perfectly.Cut with handsaws too.

[Игорь-рко]

Если предположить, что это инструкция. И следовать этой инструкцией-то ничего не получится. Можно предположить, что это розыгрыш, чтобы люди помучались? Те, которые захотят воспользоваться данным приёмом. А для тех, кто всё-таки воспользуется, не забудьте подложить под нижний конец заготовки точно такой же брусок, который торчит из стены (такой же толщины.) Только так, можно сделать точную разметку.

[MrMagsimus]

I’m glad people on here know their stuff and tell us what crap this is … saves simpletons like me wasting time and money ❤

[sheldonharvey]

Thank you for the video.
I have needed such a cut, for an end rafter. The contractors with whom I have spoken either don't know this or did not want to share the information.

Thanks, again, and keep up the good work.