Two-Post Lift Install

[JS2] Two-Post Lift Install. This shows the installation of our Dannmar M6 Two-Post Portable Lift.

The short 2 Ton Tripod Stand shown is at:

The background music is "Eine Kleine Nachtmusik" by Mozart, one of our favorite pieces.

[Mattheus]

I'm a simple man. I hear Scott's voice and I smash the like button.

[williameger]

Great video I am in the process of ordering one now. I have the 4 post but the 2 post is more versatile and the portable one is the icing on the cake. Just a suggestion, buy some counter sink bolts and install them in the holes when the lift is stored. You probably all ready thought of that. Thanks again for the video. How it was shipped was important for me to see.

[CHIBACRV]

Fantastic, I see you did not install new footings in the concrete floor for the post..can you tell me the thickness of your floor and if you know what p.s.I. Concrete they used ? Say 2500 or 3000 p.s.i or better .. thanks it will be very helpful if you know..awesome old school pick up..👍👍👍👍👍

[mechanic]

just sold our used mohawk 9000lb&15000lb lifts they were the best i do like the Dannmars m6 i have 9ft ceilings in my 3 car garage

[bradpj]

Helpful video. Are the lift arms long enough to reach jacking points? I'm considering this model of lift, and on my '63 GMC Suburban the jacking points are under the front and rear suspension, nearly 10 feet apart! Trying to figure out how to make that work.

[ShadeTreeVT]

do you put button head cap screws in the anchors when the lift is stored or just blow the holes out before you set the bolts back in? I'm thinking about getting this lift for myself, but I feel like I would be worried about the holes getting filled up with gunk in between uses. Thanks and great video!

[timmccoy]

What is the cost also what is the average depth of a normal garage floor? If purchased do you install?

[Holaroznic]

Is the height been enough for you? I like the versatility of the Jack, but I'm curious if it grows burdensome over time doing certain jobs.transmission?, clutch?. Stuff you might be under there for a minute?.

[thomasejk]

What width did you end up picking for post to post, I order one and cut out some templates to pre drill so when the lift arrives I can install quickly. I'm just not sure how far to space the post apart yet?

[reaperronin]

Been thinking about one of these for some time now...
Thank You For Posting..!
Can you tell me what the max lift height is...
Thank You..

[timothypifer]

Where did you get those mid rise tripod jacks? Could you include a link?

[stephenrecknagel]

Have you had any issues with the carriage assembly binding inside the columns on the way down??

[pastorraudel]

What’s the difference between the MaxJax and this lift?

[Nobody-nzvy]

Dang it, you’ll have to call customer service to see about that Mustang.

[turblolovertr]

What torque spec, if any, do you tighten down the posts (bolts going to the anchors) to for install?

[thieninh]

What is the cost of this lift?
Thanks.

[gabrielyberto]

Se muestra solo el ensamble de un elevador👎