Close Look At Amazon’s A-Premium Front Driveshaft: How To Setup Pinion & Caster Angles On Jeep Tj XJ

In this video I install Amazons new A-Premium Front driveshaft on my Jeep wrangler tj. We take a deep dive in comparing this driveshaft to jeeps stock OEM Spicer driveshaft and see if there are any major differences in quality and performance. We also set up pinion and caster angles on the front so we can give the new driveshaft the best possible change in longevity. Is this driveshaft a good bang for the buck? Does it fair to the OE spec or other aftermarket products on the market? Find out in this episode of ATEM OFFROAD. Thanks for Watching 🍻

Tools & Links:

Grease:

The “GlueTread ” kit that replaced my spare tire:

OPENROAD 4WD
10% OFF USE PROMO CODE: ATEM10

OPENROAD4WD Panther 2 13k Winch
Synthetic/ wireless

DISCLAIMER
Due to the factors out of control by ATEM OFFROAD, we cannot guarantee against improper use or unauthorized modifications of this information ATEM OFFROAD assumes no liability or responsibility for property damages or injuries incurred as a result of any information contained in this video. Use this information at your own risk . ATEM OFFROAD recommends safe practices when working on vehicles and or with tools seen in this video, any injury damage or loss that may result from improper use of these tools equipment or from the information contained in this video
Is the sole responsibility of the user and not ATEM OFFROAD. Be Safe

This video and description contains affiliate links which means if you click on one of these product links, I’ll receive a small commission. Thank you

[Gunmetalbluejeeptjs]

Great video and attention to detail 🔥🔥🔥

[suparee]

Great video! Are you intersted in Jeep lighting set sponsorship?

[moabwheeling]

Well, it seems to be a well made driveshaft . Hopefully it will last for a long time. I run Adams shafts on my Tj just kind of peace of mind .Not saying the Adams shaft won't fail, but for what I payed for them I hope not. I think I mentioned this to you before but we both run the same Barnes skid plate. Just curious, do you run a motor mount lift with their skid plate? Take care and looking forward to your next video.

[campoutwestus]

Hope it works well, drive line vibrations drive me nuts!

[eversleyowl]

Another excellent video - great job.
Do you think the zmount of extensikn left on the drive shaft is less because you pished the axle forward an inch? I presume no issues from that ij relation to any inteference?

[chineseempanada]

Do I need to zero the level to the floor I’m working on if it’s not level?

[yrigoyen]

Great video, but just wondering whats the need for jam nut , probably a stupid question?