✨ Bosch Oven - Bake Element - Easy Replacement ✨

✨ Bosch Oven - Bake Element - Easy Replacement ✨
How to Easily Replace A Bosch Bake Element 👍
QUICK AND EASY APPLIANCE DIY REPAIR VIDEOS – SAVE BIG $$$ BY FIXING IT YOURSELF✅

✨ If the video was helpful, remember to give it a Thumbs Up 👍 and consider Subscribing. New videos every Saturday ✨

-If My Advice Has Helped You…

Disclaimer:
Because factors beyond the control of Scottthefixitguy, I cannot guarantee against improper use or unauthorized modifications of this information. Scottthefixitguy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Scottthefixitguy recommends safe practices when working on appliances and vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Scottthefixitguy, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Scottthefixitguy.
Thank you 😊
PLEASE HELP TO KEEP THIS SERVICE GOING - THANKS SO MUCH😀



USE THIS CODE TO GET 10% OFF : M5PV3CLC2X

Join Our Channel To Get Access To Perks:😊

Check Out Scott’s over 600 Appliance Repair Videos At Our 2nd CHANNEL:

CLICK HERE TO SEE OUR NEW TESLA 🚘⚡️ CHANNEL:

.
USE THIS CODE TO GET 10% OFF : M5PV3CLC2X .
.
DISCLAIMER: This video or description may contain Amazon affiliate links, which means that if you click on one of the product links and buy the product, I’ll receive a small commission. Thank you for supporting this channel.

Scott The Fix-It Guy *
*
***

[pkittle]

Just did this replacement on my Bosch HBL5720UC/08 wall oven + microwave built in unit. Very helpful video. One tip: when you're ready to put the new element in, push the insulation up and out of the way, use a flashlight to look in, and identify the little clips inside where the element goes. I had to use a yardstick to push the small cross-member front wire on the element up and over the clip in the middle in order to install it. Wiggling as you suggested didn't work for me -- it was definitely impeded by something -- so I cleared the insulation out of the way so I could see what was in the way.

[DavidBump]

My lower element (HIIP055U) was behind a vertical piece of sheet metal that wrapped down below the oven and ran all the way to the front in one continuous piece. After looking for alternatives, I finally decided I simply had to bend that piece down out of the way, after noticing that there were two slots in it that were elongated above the element terminals such that when you bend it down, they would clear those terminals. Then as you say, I could wiggle it out. Bending it back wasn't as horrible as I expected, and it actually looks untouched once I replaced the original screws.

[stewartabercrombie]

Scott I pulled the broiler element out to replace but the electrical wires on the back pulled off and got lost behind the opening, ,, how do I find those wires

[scottwood]

hello I have just replaced the element on my oven.. it is normal for new parts to emit a strange plastic smell isn't it? Just for the first few uses.