👀 DIY PRESS IN BEARING TOOL RESULTS

Just remove CV-AXLE to use this tool! If no alignment adjustable fasteners are removed or disturbed to get the axle out, the alignment will not be changed.

[EasyFixShaun]

Here are some press tool kits on amazon. I make money from purchases. Thank you!

[sweettony]

Wait. No rust? No sledgehammer? No torch? Must not be in Maine.

[joejizel]

Really love you put everything used in the description( even for the dog). Lots of videos of how to will show the job getting done but never mention with what tools. Being is the associates program is great for you and me! I can get the tools needed and help your channel at the same time. Great information all around, thanks and keep them coming!

[Mick]

I use the same tool but it is much easier to do everything if you take out the whole knuckle off the car. I guess it depends on the car and space available to work . Good job 👍

[mmpwxln]

Смутные сомнения меня тревожат. Я такие подшипники 10 тонным прессом давлю, и некоторые экземпляры так прихватывает, что пока кувалдой не долбанеш под нагрузкой, хрен стронется обойма.

[TJayMid]

I loved the ‘Army Man Air Attack’ sound effect, really took me back to my childhood

[christianjohn]

Damn brother you make it look too easy

[OGCrypto]

My job this weekend along with a driveshaft

[ricardo]

Great, and thanks for listing the tools!

[ultimatediyguy]

I’ve done press style wheel bearings the same way you just did and you made that look so easy, when I was done I felt like I just go done doing the NFL bench press competition I was in pain😂

[dillon_r_hansen]

If you guys buy that OMT kit just stop by the hardware store for a high grade nut to replace the one that comes with the kit. Stripped out the nut halfway through pressing the first bearing out. Otherwise a decent kit for the $$.

[CROFTY]

Looks like a slick tool. Did you use the same tool to pull the hub. ?

[All_is_self_co]

It took me 4 bearings to get the right. I kept using the press and pushing the new one out the back 😩

[scissrface]

Wont the impact damage the new bearings, even if its a little.

[vahagnmelikyan]

Nice. So that's what they're for

[lonesoldier]

If I take off my old bearing and it's a nonsealed bearing can I by a sealed bearing and use that instead to mske the process easy

[LifeWithMadManWildBill]

Where did you get the bolt my kit came with a bolt that stripped and seemed to be a different thread

[ohKillemRevolk]

That bearing was drier than Barbara Walter

[skylarscoles]

Too bad it was 2 different bearings used to make this

[AdventureFreak]

Also, the same process I use to pass grocery store discount sushi.